|
Are you a bit confused about how to install Neon under car lights on your vehicle? What about the wiring, do you know colors are important when wiring up neon car lights? Well if not we'll show you how to install the under car lights onto your vehicle in the fastest and most easiest way.
First of all, before doing "any" electrical work on your vehicle always disconnect the battery before starting. Do this by disconnecting the negative battery cable.
Performing projects on cars, like installing Neon under car lights, involves drilling holes into the body of a vehicle, its very important to first check the locations where you're going to mount the under car lights, to be certain you won't pierce or damage any crucial parts such as brake lines, fuel lines and electrical lines, etc.
While the vehicle is raised up on a lift or jack determine the best location for the neon tubes. Make sure they are away from all fuel lines, exhaust systems, areas of extreme heat, moving parts, and areas where a lift jack is used to raise the vehicle.
The easiest way to mount the under car neon lights is to start screwing in the brackets first, (supplied in the kit) then holding the bracket in place, insert and tighten the screws into the holes. Make sure that the wires coming from the "side" neon tubes are facing the front of the vehicle. It's best to tighten the screws just enough to hold the bracket in place, then go back after once you almost finished and individually tighten each one until it seats firmly.
Next you'll need to locate a spot to mount the neon light kit transformer. The preferred location will be somewhere near the battery in the engine compartment and you'll need to drill mounting holes for attaching the transformer.
The power wire on the transformer can be connected directly to the Positive side of the car battery or to any 12V power wire under the dashboard. There will also be an "Earth wire" or Negative ground wire for the neon car lights that will need to be securely screwed to the chassis of the vehicle, or to any "Earth wire" to complete the power circuit.
The on-off switch should be mounted in a convenient location on the dash and within your reach. Wiring for the switch can be run through a grommet in the firewall, into the engine compartment where it can be connected to the battery. The switch and fuse, that will be included in your neon under car lights kit, should be connected between the transformer and the power supply.
All you need to do now is to plug all the neon tubes into the transformer and complete any additional wiring according to your kit instructions and then you'll be all set to show them off!
Please see our "More-In-depth" and step-by-step picture illustrated instructions on the How to install Neon under car lights page.
About the Author:
Antonio Gabellone is the Owner/Author of All-Neon-Car-Lights.com - The Site is a great resource aimed at Neon Car Lights and LED lights with "life-time Warranties". Copyright© All-Neon-Car-Lights.com 2003-2009 - Permission is granted to reprint this article provided the webmaster supplies a *LIVE* link to the authors website. |
tweet this!