When machine embroidering large and/or stitch-intensive designs I use this hooping technique to make certain the fabric will not pucker or move during the embroidering. It is especially useful when embroidering those designs that have an outline because even the slightest movement of the fabric will cause the outline to be noticeably off.
The steps pictured below show how I do it and what works for me but that does not mean it is the only way or even the right way. Please keep in mind that this hooping technique is by no means for all machine embroidery projects. It is a machine embroidery hooping option and finding what works best for you is a matter of good ol' trial and error.
Why Sulky Sticky?
I like the Sulky brand because:
It has a grid that comes in very handy for positioning.
The slightly waxy paper coating over the sticky has enough tension to prevent it from slipping in the hoop. I've tried a few other brands and found just the opposite to be true. The stabilizer kept moving when I tried to hoop it. Not so with the Sulky brand.
I have also found the Sulky paper coating easier and quicker to remove than other brands.
Now, let's use this technique to embroider!
Hooping the Stabilizers
Here I am hooping the Sulky Sticky and a layer of tear-away stabilizer in a 5" by 7" hoop with the sticky on top. I cut both stabilizers a little wider and longer than the hoop.
The Stabilizers Hooped
Be certain the stabilizers are secure in the hoop: Tight, flat and without puckers or bubbles.
Like a Tambourine
Turn your hoop over and check to see if it is 'tight as a drum' or like a tambourine. Betcha can't resist thumping it!
Remove the Paper
Lightly score the sticky's release side and remove it to expose the sticky backing.
Mark the Sticky
Use your hoop's grid template to place marks on the stabilizer to locate the straightline center and right and left edges. Be sure to place your grid gently over the sticky with the bowed side up. Otherwise the sticky will do its job and grab onto your template.
Lining Up Your Fabric
I'm going to embroider a quilt block. Here I have my pre-cut block aligned on my measuring board where I have located the center of the block.
Marking Your Fabric
Using your hoop's grid, marking the straightline center and right and left edges of the fabric. Important: Place these marks on the backside of the fabric.
Affixed the Fabric
Grasp your fabric from the backside on the marks to make a gentle fold and carefully line it up with the marks you made on the sticky. Gently lay out the fabric on the sticky and smooth it to the edges to get good adherence all around.
Lock the Fabric
I like to lock the fabric to the part of the stabilizer that is hanging over the edge of the hoop (the part with the paper still on) just to make sure it doesn't get caught on anything while embroidering. Here I'm pinning it but double stick tape works great, too.
Ready to Embroider
And that's it. The fabric is smooth, taut and ready for embroidery.
The Embroidered Result
Your designs will come out perfect with no puckering or mis-aligned outlines!
Hooping Sulky® Sticky Stabilizer & a Layer of Tearaway Stabilizer
» left by Jessie Robertson from Prince George, BC. Canada (1 year 212 days ago.)
I have to comment... this is just so excellent, with the large clear photos of instruction! Respond to this comment
» left by Judy from Canby, OR (306 days 6 hours ago.)
Very good article with great pictures - thanks! Respond to this comment
Was this article helpful to you? Leave a Public Comment or
Question:
Disclaimer: All information on this site is provided for informational purposes only! By no means is any
information presented herein intended to substitute for the advice provided to you by any health care or other professional
or organization.
