Electric heaters heat up water with two horizontal elements running inside the tank of the water heater. One is located on the upper half of the heater, and one is located on the lower half. Elements are similar to the metal grill pieces found on top of household stoves. There are high watt and low watt elements. Low watt elements are better because they do not produce as much sediment, but they are more expensive. The lower element does more of the heating because it is wired to do so. Only one element works at a time. The upper element operates when a large amount of new cold water is introduced into the tank. Some tanks have only one element which will be located at the bottom of the tank. The top element has a high temperature shut-off switch which will turn off the element if the temperature reaches 190 degrees Farenheit. In single element tanks, this same feature is found. It comes with a red reset button similar to a GFI found on household electrical outlets. An adjustable thermostat is found on the lower element located on the outside of the tank. Thermostats are usually all set at 120 degrees Farenheit.
Gas Controls
Gas heaters have a thermostat which is directly placed in the water, and it is connected to the front control apparatus at the bottom of the water heater. A dial is found on the apparatus which has settings: ON, OFF, and PILOT. The knob located on the top of the dial apparatus has a recessed screw which controls the gas flame. If the temperature ever reaches 190 degrees inside the heater, the control itself will be shut down and cause the flame to die. A new control will have to be installed if this ever happens. On older heaters the control will shut off if the temperature reaches 210 degrees. Three tubes extend from the bottom of the dial apparatus. The largest tube, alwasy the middle tube, is the natural gas supply. The medium-sized tube, usually to the right, feeds gas to the pilot light switch so that the flame can initially be ignited. The smallest tube, usually to the left, is the thermocouple. The thermocouple gives power to the control after the pilot has been lit. If your pilot light ignites but will not stay lit, then the thermocouple needs replacement. The burner assembly is attached to the tubes and control and can be removed to clean. Do not take apart the control itself.
Copyright 2006 John Haynes
--------
Want to KNOW more than the water heater salesman before you enter the store? Check out http://www.waterheater-info.com for tips on various brands, installers, solar, tankless, warranties, maintenance, heating insulation...
» left by Sharon Lauer(231) Sharon Lauer (2 years 85 days ago.)
wow, lots of information in this article! I never really found the instructions from your title "How to adjust the temperature". For those us who don't know an element from a pilot light switch, directions in very simple terms would be helpful. I really appreciated all the info on what makes a heater heat, and going a step further to tell me how to adjust that would've been the icing on the cake. Respond to this comment
This articles' title suggest that one might visit here to learn how to adjust the temp on a electric water heater. I just read it and now I know about two elements inside the water heater. There is nothing in the article that tells me "How To Adjust the Temperature."
Disclaimer: All information on this site is provided for informational purposes only! By no means is any
information presented herein intended to substitute for the advice provided to you by any health care or other professional
or organization.
